Recent content by Recoveryone

The RC-controller will not update to the latest Flysafe database, you will need to use DJI assistant 2 (Comsumer), connect via USB C to your computer and the software will recognize the drone and do the latest update version 01.00.01.38 Aircraft, version 01.00.0797

You may need to go outside to get sufficient sats and also make sure you have strong wifi

No

You would need to check with Flir or Boson to see if they make a clip on unit for the Mavic 3 series. It will not be supported/integrated with DJI software

The Mavic enterprise line only comes with the installed payload (camera), you will not be able to swap out cameras. It's either going to be a Mavic 3E (for mapping) or Mavic 3T (comes with thermal, but not very good for mapping). If you are looking at something that will allow you to swap out...

Glad your not the one being paid for it

I see! the modded Plus controllers I've seen on Ebay. I get it now

I'm a bit confused, what mod is needed? My Pro Plus charges both batteries with no problems. I use the WB37 battery with my D2-RTK GNSS, Phantom 4 RTK, each controller charges and GNSS setup can charge the WB37 internally.

Wow, I guess people see what they want to see. Can someone pin point the time where a bird flew and if it was close to the drone? 2nd, when the drone launched I was standing next to it and walked away to not be hit with any debris, while I continued to speak I took a look at my screen which was...

I understand your concerns, I can assure you I take all the pre-flight procedures to ensure the safety of my flights. In response to VLOS, once the aircraft is in the air then the rules of VLOS apply. I know were the aircraft is at and what direction it is heading at take off, which is the...

Last you check!!! please show the reg that state that the PIC is require to watch the UAS take off???? not that I'm taking anything light, but don't quote the law if you don't know the law!

Why do I need to look at it, will it need my help by throwing it up in the air?