I've done the hack now,it just wouldn't let me do the final part ,everything else went smoothly even deleting and pasting the new file ,
Now I finally have a fcc RC remote
I ended up sending my RC serial number to sincoder via WhatsApp, I then ran the patch and I got to the end stage successfully patched ,I always got the error tried to many times wait
I've tried that ,get to the end but it doesn't say patched successfully
The other version is from dji fcc mod
That's the same as above but newer firmware, same result
I get a bit further
After I have copied and pasted the new file into qcom part b it's on about 8%,it then carries on and says the program will close and carry on in dji assistant it starts at 49% and gets to 87% then fails,I reboot RC and check if FCC mode is working ,in my case No its not its...
When I got the error at 87% I restated Rc ran the hack ,it does the hack again then I get to the same point 87% ,rebooted rc tried it will drone and it does work ,I never get the FCC successfull
That's what I did ,after the failed update I rebooted RC ,but I'm still in CE mode I never get the message FFC patch installed successfully, I've run the patch numerous times
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.