Recent content by rpguy4

Maybe I am just too frugal. I bought the regular Flymore kit (w/standard batteries). I usually only fly 2 batteries with my Air2s. The Mini3 standard batteries are rated a few minutes longer than the Air2s batteries. Just figured I didn't need the longer flight times. I then watched a YT video...

I received the Skyreat soft shell case, and received my refund. It seems to be well made, and everything fits. No complaints. Thank you

The Air 2S is my first DJI drone. With other non-dji drones, doing a compass calibration was more of a safe guard.

I have an A2S. My precision landing seem to be off about 50% of the time. Plus, altitude on take off generally spot on, but altitude when landing was off, and it was missing the pad. I figured out that what I was always doing a compass calibration before my first flight, even know the compass...

Thank you for your response. Very helpful.

I was thinking of just getting 2 strobes with one on each arm diagonally, white rear / red front. The other issue is folding the arms, and leaving strobes on when storing or carrying in the bag. Thinking I'll probably have to take them off after flying. The smaller ARC II strobes may be a better...

I contacted Firehouse to make sure these would work on the Air2s. (Yes.. this setup will work on the A2S). However, my concern is attaching them to the arms and throwing the drone out of balance. Has anyone used this setup ...

Noticing that if I cancel a RTH on the Air2s, that the sticks are not responsive for a few seconds afterwards. Tried this a couple times. Cancel the RTH close to the home point. I see the drone break, and stop. Then when I try to go forward again, it takes a few seconds for the drone to respond...

I've been using a 75cm landing pad with the A2S. It fits perfectly within the circle, and landing pretty close to the center of the pad.