Recent content by Serg_SSA

To switch the drone to ATTI mode, you can assign a button to the remote control for this. This is done by changing the drone parameters using the utility.

I tested it by turning on ATTI mode with the button on the remote control and turning on ASA by turning off GPS on the drone. The drone's behavior is different. In ATTI mode, the drone does not use the down positioning system to maintain position, in ASA mode, the drone uses VPS.

There is a message about ASA mode in the log, but it is in Russian, but it is not ATTI) I have provided the translation earlier. The reason for the crash is clear to me and does not require explanation, it is spoofing.

Opti Mode ? Is this message also written in the log? Can you give an example? Based on your information, it is possible that this is the ASA in the version for other countries. "Opti Mode being Atti Mode + VPS" this is exactly what I observe. I have only encountered Opti Mode in the GO 4 app

No, it is not. The English version has the same message. I have tested it and found different behavior. In ATTI mode, the drone does not hold the position of the lower sensors. In ASA mode, at low altitude, the lower positioning system works and the drone stabilizes.

Here is an example of spoofing This is what the flight looks like, the drone does not respond to the sticks, only rotation around the axis is possible. https://www.phantomhelp.com/logviewer/202501218ZZSOZDL3BSIH4O5P7GWQII0B43BZXCU

But these are different messages and I would like to know what ASA means. "Mode changed to Atti" "ASA mode activated".

This is a fragment of the log: Mode changed to Atti U 03m 40s 68.0 m 719 m Low Risk Weak GNSS signal. ASA mode activated. Drone cannot hover. Fly with caution (Code: 30022). Low severity, impact on safety is likely not significantDrone in ASA mode. Positioning is impossible. Fly with caution...

If there is no GPS signal, the drone will enter ATTI mode and an additional message about ASA mode will be written to the log. What is the difference between these modes?

Дрон нашел очень мало спутников, вы даже не дождались, чтобы он зафиксировал точку "дом". Разве не было крыши там, где вы летали? Разве не было дополнительного оборудования, установленного сверху дрона?

I, like many here, use the launch pad. Starting manually is not always possible; sometimes I am with the remote control not next to the drone, but in another place.

I have no problems after the update and I haven't read about any problems on the official DJI forum You're just an alarmist)

Режим P аналогичен режиму N, это не глюк. Задержка подключения решается прошивкой дрона, а не Fly; на моей 500 прошивке задержка исчезла.

В настоящее время невозможно установить новую версию Fly 1.13.1 на RC 2.

Look in the Fly app, there is new firmware v01.00.500 I installed it via the remote control. There is no firmware in the Assistant