Recent content by Tom Milne

That sounds like too much hassle plus I don't think the good lady would be too pleased if a new Formlabs printer arrived at the doorstep despite my daughter working for them in Boston!! nice to use the toys though.

Meant to ask where did you get the chunky USB cable looks like a permanent fixture now and I have not seen that style of USB end before I have the dual micro USB / lighting end as I have a few of these.

Cheers Andy fitted a small on off switch just finished it half an hour ago now charging three batteries ATB Tom

Like the power switch, I looked at this and did not think there was sufficient room need to look again I see you managed to squeeze it in at the air vent

RCstyle Multi Intelligent Battery Charging Hub Dock for: Amazon.co.uk: Electronics

I also bought one to try. I checked USB voltage and battery pin voltage and all good, I also added an earth to the box as per Peter's excellent video above. I opened up the box to check the workmanship and its all vey tidy including the soldering, note there is a sticky double sided pad at the...

Buy some ND filters the Buy some ND filters use them on My S900 (GH4 Camera) / Inspire Pro X5 Camera and now the wee Mavic also depends what you are doing but for video you want to keep the shutter to x2 the frame rate so say 4k at 30fps as an example then you want to try and keep your shutter...