Recent content by TomLopez

I tried to calibrate the gimbal but nothing happens except a timeout... I have attached a video of the startup phase: PS: I don't have a DJI refresh option but I am quite confident with repairing the drone. I already had to replace some parts of the gimbal after a crash

Yes this happened following to a crash. The gimbal is moving at startup so it should work. Unless the engine moving the cam up and down is damaged...

Hi guys, I am not able to adjust the horizon on my M2P anymore, the camera does not move. I have an error on the display eg remove the protection and gimbal engine overload but I can move the camera easily with the hand. Any ideas?

So end of my story with an happy ending: I was able to get a replacement card from Rob (Thunderdrone) and I followed the following video to replace it as well as the broken gimbal arm: My MP2 is fully functional again :-)

So in fact looks like I am screwed !! The connector of the gimbal control board is broken and I have not been able to find a spare gimbal control board. I found some but for the 1st gen Mavic Pro. It is this the electronic card attached to this post. Does someone know where I can find one...

Well if I had known I was purchasing something rubbish I would not have. I have just purchased the items that were on stock at this time and advised as "Amazon choice" ....

One of the new part has been delivered :-) Hopefully I can repair the drone by myself ...

Hi guys, Thanks a lot for your informative feedback and ideas :-) I have been digging a bit more since Sunday and found out the following spare parts on eBay: -...

Hi guys, Yesterday the front left propeller broke and I notice that my drone was dangerously loosing altitude. I recon the place and initiate a landing on a grass field but unfortunately I lost control with the remote. When I got signal again, the drone was not landing anymore but flying...