Recent content by tpdtopcop

Just replaced the sensor ribbon cable not the whole sensor. Yes there was glue on all cable attachments and I put hot glue on from which I removed. I am getting red signals when drone gets to close to things.

Yes reinstalled the firmware. Factory reset done. Still getting error. Again replaced the downward vison sensor cable because of the issue with the original cable. When flying drone I can place my hand under the sensor and the drone will go higher as my hand goes higher so I believe the sensor...

There is no way to calibrate the downward vision sensor for the mini 4 pro per the DJI website.

Thanks for the reply. I did replace the Downward Vision System to Core Board Flexible Flat Cable because of the bent pin. Are you saying its really not the downward sensor?

Crashed drone and broke right front arm. Replaced arm and Replaced Downward Vision System to Core Board Flexible Flat Cable, as I bent one of the pins when I re attached original cable to mother board. Now I am getting this error, however while drone is in flight if you put your hand under...