I'm just about the do an IMU calibration. Does the surface have to be perfectly even and if a look it from a bubble level the bubble has to be in the center perfectly?
Or is it fine if it's like 0.5 degrees off?
Thanks Peros550 for the info. Haven't tried IMU calibration yet, but did gimbal cal. and firmwares are up to date.
Could you link the video for the gimbal video? I couldn't manage to find it on DJI's website or youtube channel.
It seems like I found the source of the problem in my case.
Basically those vibrations happen when the Mavic jumps a tiny bit. But since it was recording video with very short shutter speed (usually above 1/1000th/sec) it emphasised the bump and created those artefact.
Now that I've used it...
Has anyone experienced these horizontal vibrations/blurring like on my attached video?
I have noticed that my Mavic's camera or gimbal sometimes produces these horizontal vibrations/shakes. Flown 4 hours so far and it happened 6x times. It usually lasts for 1-2 seconds.
Calibrated the gimbal...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.