I have discovered an option in the SLIC3R program "generate support material" that added temporary support structures . I just need a cable that can reach into my Otter to connect to the controller. What did you use Dan?
I have an ATI Radeon HD 6000 series
The installer reports a problem installing when trying to install the AMD software.
Embedded AMD Radeon graphics
I did use Alan's version of the screw. Seems to work well.
Now I have issues with the clamp since it needs supports as I can't print into thin...
Alan, when I go to slice the short screw using slic3r, the screw threads are not there. My PC is limited to this program as my graphics card is tool old to install OpenGL. Do you have a file that I can work with? The long screw looks fine.
I had the same situation but it was my fault. When it reached the maximum altitude I set the Dronie failed and it stayed there. Did this happen to you, When I set the maximums correctly it all worked.
I'd like to get a sounding of where people are flying their drones in this area. I fly my drones at the Atlas Tube Center soccer fields. Lots or room for experimenting. I think this is a good place when the fields are not in use.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.