All motors are the same. Rotation is determined by how they are wired to the board. The board shows which colour wire is soldered to its connector
Plastic rings are screwed to the rotating part are colour coded as in with or without a white ring for direction of spin
normally the self discharge in storage is cleared by turning the drone off and then on again.
if the setting for the time to discharge is set to 1, the red top message would be there again.
they are small hexagonal type drivers. if the local diystore doesn't have anything go to a mobile phone shop as they have similar screws..
e bay is a good source as well..
when you open it up check the wires to the motors are still glued down and the ferrite ring is still round the wire to the...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.