Recent content by Yousuf110

I cant believe i found out what it was.... it was a thick wire from my battery mod. The wire went from the positive terminal to the side where the motor arm joins the drone, somehow, this was causing a vibration or something, or pushing against the drone arm, therefore it was vibrating and i...

Thanks mate, i replaced the whole motor arm... brand new one. And STILL getting the motor obstructed error, i thought it was a firmware issue after that. So i re flashed the firmware, and i am still getting it. I really dont know what else i can do.

Ofcourse it works, it uses 2.4ghz which is wifi, ocusync just enhances it. Do a search on here for wifi boosters and you will see.

It looks exactly like your one, you might also want to get Wifi boosters which are 1.5 watts, get 2 of them and put them on your remote, you will have to modify and open your remote.

I have solved this issue, what i did was attach a small heat transmitting fan to the lower side of the gimbal, its very light, and produces enough heat powered by a lipo battery to counter the fog effect.

Yes i am using android, i get 500M without FCC, but with FCC Boost of 1.5W, i get nearly 3 km in a busy urban area with lots of signal interference.

Its best to use an Android phone, much easier, all you have to do is install DJI force boost app, click FCC and all done.

Hello all, I get an error saying "motor obstructed" and my top left motor has a vibration sort of spin, and then for a while it spins well then vibrates at different intervals. I dont believe there is anything stuck in there, as when i spin it by hand i dont feel anything obstructing it. Does...

Hi mate, Follow this exactly, i had the same issue and rolled back successfully. The ALT restriction was done via these steps, if you have a mavic with no SD installed originally, you must do these CAREFULLY or you will end up like me spending ages figuring it out: 1. Using DJI assistant 2...

Send me a private message mate, i will help you get this running again, your mavic is built on June 2018, which means you will need to open it and insert SD card. I spent days trying to get mine fixed also with the same issue, until i finally resolved it.

What is the serial number on your drone? it should be where you insert the battery. DJI SERIAL DECODER Type it into there, and let me know what it says, then i can figure out if you need to open it or not.

It does not have to connect to remote to be able to flash it. Connect it to your computer via USB cable and it will connect to DJI assistant 2.

Hi mate, i had exactly the same issue as you. Follow these steps exactly and your mavic will work again, with no limits! Follow this exactly, i had the same issue and rolled back. The ALT restriction was done via these steps, if you have a mavic with no SD installed originally, you must do...

It wont work, you can flash it without SD card, but when you try to take off you will have SD CARD ERROR, not allowing you to take off.

Follow this exactly, i had the same issue and rolled back. The ALT restriction was done via these steps, if you have a mavic with no SD installed originally, you must do these CAREFULLY or you will end up like me spending ages figuring it out: 1. Using DJI assistant 2 latest version, flash...