Mavic 2 zoom.
had a crash where the gimbal/camera was ripped off midflight.
otherwise drone seems ok.
I've since ordered a replacement gimbal/camera but it will take a week.
in the meantime I'd like to make sure the drone will otherwise be ok once I install the replacement.
when I turn drone on all is ok.
but the firmware shows red and drone will NOT take off.
error 200.
is this because there is no camera/gimbal attached? (it's just ripped wires)
just wanna make sure once I install the new one that I will be ok to fly and the error goes away..
anyone have insight?
(there is currently NO gimbal/camera attached)
would the Mavic 2 be able to fly without a camera attached? and will error 200 go away once I install new camera?
thanks !
(my first post!)
had a crash where the gimbal/camera was ripped off midflight.
otherwise drone seems ok.
I've since ordered a replacement gimbal/camera but it will take a week.
in the meantime I'd like to make sure the drone will otherwise be ok once I install the replacement.
when I turn drone on all is ok.
but the firmware shows red and drone will NOT take off.
error 200.
is this because there is no camera/gimbal attached? (it's just ripped wires)
just wanna make sure once I install the new one that I will be ok to fly and the error goes away..
anyone have insight?
(there is currently NO gimbal/camera attached)
would the Mavic 2 be able to fly without a camera attached? and will error 200 go away once I install new camera?
thanks !
(my first post!)
