Frustrated by latest firmware update to Mavic 3 Pro

[dmwfotos]

I up dated the firmware last night for Mavic 3 Pro and the RC.
Now it won't take off.
Everything seems right but drone just sits on the ground when I try to take off.
Any suggestions?

 

[GFields]

Try updating again

 

[mobilehomer]

Try updating Fly and the controllee.

 

[TonyPHX]

agreed. Known issue. Update fixes it.

 

[chadCO]

Revert the firmware back to a working non broken version.

 

[Sublime]

Revert the firmware back to a working non broken version.

Are there known issues with the newest updates? Loosing video feed twice now while switching shooting modes mid air

 

[TonyPHX]

Are there known issues with the newest updates? Loosing video feed twice now while switching shooting modes mid air

@Sublime From some personal experience recently, my working theory is that if the camera chip is overheated that you will see some flakiness when switching shooting modes. Too long of a story to tell and totally defend my thoughts, but over time with the 3 series (various models) I have seen that if I am relatively static and there is not a lot of airflow, the camera chip can get hot and then various forms of flaky happen. Knowing that it can be a heat related issue can help you perhaps cruise around and cool it down, assuming you are also seeing this when the drone has been somewhat stationary. If not, then my advice probably is not helpful for you.

 

[janelewbill]

Revert the firmware back to a working non broken version.

How do I do that?

 

[janelewbill]

Revert the firmware back to a working non broken version.

How do I revert to the previous version of the firmware?

 

[Filmarik]

How do I revert to the previous version of the firmware?

Through Assistant 2 software. Download from DJI website and install into your comp. You need to connect your drone with USB cable to your comp. Open Assistant 2 and go from there