Mavic 2 Pro warnings that I can't seem to remedy

[Mudbone]

Attached is a pic of the "warnings" I get at startup... I launched DJI Assistant on my mac but all it was allowing me to d
was a firmware update, but I am already on the current firmware... nothing specific on calibrating vision sensors. And, it was telling me
my remote ID functionality is normal yet there is a red flag (triangle) next to it suggesting there is some kind of problem (?) These prompts
are confusing in that the DJI Assistant doesn't offer any solutions that I can see...

Has anyone else seen this?

My thanks in advance for any and all advice and/or suggestions...

 

[slup]

This is how it should look in the upper left corner in DJI Assistant 2 when you have connected the powered drone to your MAC...



Have you tried the calibration there ?

 

[RadioFlyerMan]

Attached is a pic of the "warnings" I get at startup... I launched DJI Assistant on my mac but all it was allowing me to d
was a firmware update, but I am already on the current firmware... nothing specific on calibrating vision sensors. And, it was telling me
my remote ID functionality is normal yet there is a red flag (triangle) next to it suggesting there is some kind of problem (?) These prompts
are confusing in that the DJI Assistant doesn't offer any solutions that I can see...

Has anyone else seen this?

My thanks in advance for any and all advice and/or suggestions...

Don’t worry about the remote ID red triangle. If you click on it, it says RID is functioning properly. On boot, it takes a while to appear as it has to acquire GPS first.

 

[Mudbone]

Thanks RadioFlyerMan!

 

[Mudbone]

This is how it should look in the upper left corner in DJI Assistant 2 when you have connected the powered drone to your MAC...

View attachment 181109

Have you tried the calibration there ?

Thanks Slup!... Like a dummy I had my controller connected. When I connected the powered up drone (DUH!) all was fine!