Mavic Air 2 Error Beeps After Power Up

[BunnyHadger]

I recently allowed an RC car to smash my drone in the face and had to replace the gimbal arm.

After placing the old camera sensor into the new gimbal housing (this is a must as it screws up the serial number activation check) and completing reassembly I turned it on and got the gimbal to play nice but am getting odd beeps when I attempt to power it down.

When I tap the power button twice and hold to power off I get 3 tones, first a long tone and then two short tones. I have to tap the power button a bunch of times and then hold it down to power it off.

Anyone have any experience with this issue? I have yet to find any other notes indicating a similar circumstance.

Here's the youtube clip referenced above.

 

[Drone Master]

Have you tried refreshing the aircraft FW?
Usually when replacing components will require the new hardware to match the existing FW. Especially with gimbal components.
Give it a try.

 

[MavicRoolzOK]

Not sure if related, but you might try recalibrating the joysticks too as per

? I found this helped perfectly after I hadn't been using my MA for a while. If irrelevant, hope you get it sorted another way !