Greetings all.
Yesterday I tried to fly my Mavic Air for the first time in 4 or 5 months.
Did everything by the book.
Fully charged Batteries and Remote.
Set drone in my usual spot.
Turned on Remote.
Turned on Drone. Noticed I had 15 Satellites.
DJI Go started to show on my Galaxy S9.
Had to try and connect manually with "Enter Device"
Did everything by the book.
Re Calibrated.
However, I could not get the Controller to change from Red Light to Green Light even though the drone was flashing Green Light.
I was able to manually lift the drone off the ground to hover about 1 meter off the ground, and was able to manually land again with the slide function on my phone.
That was all.
With the Red Light still displayed on my controller, I had NO toggle action what so ever.
Any ideas for an old man who is not that tech-savvy.????? PLEASE
Thanks if you can assist.
Yesterday I tried to fly my Mavic Air for the first time in 4 or 5 months.
Did everything by the book.
Fully charged Batteries and Remote.
Set drone in my usual spot.
Turned on Remote.
Turned on Drone. Noticed I had 15 Satellites.
DJI Go started to show on my Galaxy S9.
Had to try and connect manually with "Enter Device"
Did everything by the book.
Re Calibrated.
However, I could not get the Controller to change from Red Light to Green Light even though the drone was flashing Green Light.
I was able to manually lift the drone off the ground to hover about 1 meter off the ground, and was able to manually land again with the slide function on my phone.
That was all.
With the Red Light still displayed on my controller, I had NO toggle action what so ever.
Any ideas for an old man who is not that tech-savvy.????? PLEASE
Thanks if you can assist.