Recent content by highcrow

****, I have a plan to shoot surfers this Sunday, and this issue worries me. When this issue happened, it showed -8ft altitude... I cant fly my drone with wrong information...

I really hope firmware update fixes this.

Thanks forvthe reply. No solution means send it back to DJI, right? Sigh... I already sent mine once to fix gimbal calibration problem, now this...

I made a new thread about it, and your issue is very similar to mine. My mavic stopped recording video when this thing happened and altitude was showing -8ft when it was flying over 30ft. I guess I need to contact DJI to solve this issue..,

I had really weird error problem today. So I was flying my mavic a beach side, and everything was smooth. Then about 10min flying, the screen shook, and it seemed like it was going to shut down(flickering), it did 3 times then the video setting was back to yesterday's setting, the altitude was...

You can check it with the air line. I believe you can carry it with you in the air plane. You can wrap your additional batteries indivisually, and carry them with you too.

Set to low, then you will see red lines.

What is the battery mods?

Its been raining here so I have not tested it yet...

One question though...should I downgrade both rc and Mavic, or just mavic?

Ok, I tested 2 times, and it is official that I get worse signal from the new FW. I have the same route that I test Mavic all the time, and this is my first experience lost both rc and hd signal. It was scary. First the HD signal dropped significantly and lost the screen, than a few sec...

I have the same problem... sigh... time to downgrade to older FW...

Hello, I have taco nd filters, and normally, I install the filter then turn on my Mavic. I am just wondering its ok to swap nd filters while Mavic is on. The gimbal is so fragile, I feel like swapping filters can be not so good idea...

Weird....the update supposed to make the signal better.... any other members have this issue?

So what can I do to solve this issue? is there any way to test or boost my signal range? Maybe something is not right with either my RC or Mavic