Recent content by robcio

Not yet, I check the props done some calibrations and same issue. I have not been able to fly the past couple weeks so will have another look shortly.

I tried an IMU cal and also new props and this sound still appears. The motors all seem fine as well. Cant think what else it would be

Thanks for the tip, I haven't yet had a chance to look into this further but ill give this a go this afternoon.

I had not heard this sound until yesterday. The drone had only been stored in its bag prior. jeff, The drone did not make this sound without the props on which makes me think this maybe the cause?? Ill install new props and see if this makes a difference.

Jeff, i did take off the props to check for damage and they visually appeared fine. I also ran the motors without the props and this appeared fine also. I will check the props again and install new ones too see if this is the cause of the problem.

I dont think that is the sound as i only noticed the sound recently with the props spinning, also the hovering of the drone is not as good as it was previously.Coincidence? Ill take another look when i get a spare movement and see if it is indeed the sensors. Thanks for the advice.

See video. You can slightly hear the sound

Took my Mavic out for its first flight since updating to the latest version of firmware. What i did notice when i started my Mavic that there appeared to be a pulsing sound which i had not noticed prior to the firmware update. The mavic was also not as stable under hover than what it was...

Will stick with the Mavic for the time being

These are unedited HD Sync images i took on my 2nd outing. Any feedback on the image quality will be appreciated. Thanks

I have tried gimbal roll and the centering option and both did not seem to fix this issue.

Received my mavic about 2 weeks ago and have just realized the camera / gimbal is slightly angled to the right. I tried a gimbal cal etc etc but this did not seem to fix the issue. Has anyone else experience this issue and found a resolution? Thanks

When i first received my Mavic - Completed firmware upgrades i also had the problem where the gimbal tilt dial would not work. After a factory reset of the firmware and fresh install of the updated firmware it fixed this problem. Has been working fine since then.

3 as I ordered the Fly More Combo. Just getting into the hobby so may need to expand in the near future

I also received the combo pack last week. Have use the bag twice and also found it to be too tight. Time to try find another.