DJI Fly and Air 2 Firmware installed today.
Latest 1.4.12-xxxx build installed onto a Smart Controller. Latest firmware installed onto a Mavic Air 2, all batteries updated.
Both controller and drone compasses calibrated immediately before doing this test.
To replicate the issue, place the drone facing north, move ~25 feet to the east, point controller north.
Quesion is: Which way should the controller dot arrow point?
I expect it to point towards the drone, to my right. But, the image below shows what I see. Second image shows overhead map of my setup.
If I turn the controller towards the drone, the arrow moves and when the controller points at the drone, the arrow does point at the drone (and turns green). I'm pretty sure, not 100% though, that 1.4.8 the arrow always pointed at the drone, so you knew which way to turn to keep the antennas aligned.
Latest 1.4.12-xxxx build installed onto a Smart Controller. Latest firmware installed onto a Mavic Air 2, all batteries updated.
Both controller and drone compasses calibrated immediately before doing this test.
To replicate the issue, place the drone facing north, move ~25 feet to the east, point controller north.
Quesion is: Which way should the controller dot arrow point?
I expect it to point towards the drone, to my right. But, the image below shows what I see. Second image shows overhead map of my setup.
If I turn the controller towards the drone, the arrow moves and when the controller points at the drone, the arrow does point at the drone (and turns green). I'm pretty sure, not 100% though, that 1.4.8 the arrow always pointed at the drone, so you knew which way to turn to keep the antennas aligned.
Last edited: