Yeah that's my mavic it dropped from 300ft with a motor obstructed message.. I'm just amazed I was able to locate it.. when I turned it on.. I thought I seen a little Puff of smoke so I took it apart and tried turning it on again
When I found it was upside down with battery still connected but dead and all four props loaded with grass dirt.. also was infested with those little tiny ants that I didn't notice till iwas driving home with it on my lap...does anyone no if there's a way to figure out which motor got obstructed a few minutes into my flight
Need a little advice Please.. I installed my new ESC main board tonight and it fried instantly ...now I no it's one motor.. i figured that out after removing the one motor and started it up again and the thing boots up and runs with one error saying ESC error.. I can turn it in at least with 3 motors connected ..butt I no the board is toast... So before I buy a new ESC board again and a motor or probably two new fronts ..is there a better way to test the motors ?? Like other than just connecting too a battery and see if they spin.. I actually tested all 4 motors that way and they all spun..butt a motor is burnt up a new board ..same scorched location as my other board...hopefully im explaining this good enough for y'all to understand .. so basically does any one have a procedure (like maybe how I could test with a multimeter)how to test the motors ??? So I no there A O K to use...at this point im just going to buy all 4 new ...stressed sorry if im stuttering ..
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.