Mavic Pro Crash

[G7799]

Hi everyone, yesterday stupidly crushed my drone into the wall flying backwards. Drone is fine, lost propp and got few scratches.
When i turn it on gimbal calibrates fine but it does not calibrate with ND filter on it (was calibrating perfectly)
any ideas whats wrong? Gimbal does not have any visible damage.

 

[Thomas B]

What brand of filter?
When you remove the filter and start up without it since that event does the “gimbal dance” occur normally?

 

[G7799]

What brand of filter?
When you remove the filter and start up without it since that event does the “gimbal dance” occur normally?

Nd filter is Skyreat, never ever had any problem before crash.
Without filter calibrates perfectly

 

[Thomas B]

Nd filter is Skyreat, never ever had any problem before crash.
Without filter calibrates perfectly

Did the drone/controller give you any message?Maybe post your logs. Sounds like gimbal motor or gimbal cable damage are possibilities.

 

[Dr. Bill 1969]

Hi everyone, yesterday stupidly crushed my drone into the wall flying backwards. Drone is fine, lost propp and got few scratches.
When i turn it on gimbal calibrates fine but it does not calibrate with ND filter on it (was calibrating perfectly)
any ideas whats wrong? Gimbal does not have any visible damage.

As Thomas B. suggested check or change out the gimbal ribbon cable. This cable is a known weak spot on the Mavic Pro(1st series).