MV goes to landing mode on high altitude

[andry]

flew my MV a days ago.Auto-landing activating at high altitude
- firmware .0800
Trigger: - I pushed the throttle down (full / half / a bit trigger this issue)
- My drone accelerated and started to go down very slow (speed like 0.2)
- i can cancel the landing with push the left up
- all other controls stayed active (camera / right joystick) which allowed me (fortunately !) to position the drone over a safe landing zone

seems MV sees the ground at high altitude, how to solve this?

 

[Kilrah]

How high?
Over land or water?
Bottom sensors clean?

 

[Bunny Too]

flew my MV a days ago.Auto-landing activating at high altitude
- firmware .0800
Trigger: - I pushed the throttle down (full / half / a bit trigger this issue)
- My drone accelerated and started to go down very slow (speed like 0.2)
- i can cancel the landing with push the left up
- all other controls stayed active (camera / right joystick) which allowed me (fortunately !) to position the drone over a safe landing zone

seems MV sees the ground at high altitude, how to solve this?

Check all your downward sensors and make sure they are clean and clear.

 

[andry]

yes i belive it clear the sensor , about 70ish feet beach area ( i flew still near me, pretty much in gound area, 65~70 feet high, 5pm sunset)

 

[Bunny Too]

yes i belive it clear the sensor , about 70ish feet beach area ( i flew still near me, pretty much in gound area, 65~70 feet high, 5pm sunset)

Sometime the sun can cause the sensors on the drone to get confused, just a thought.

 

[andry]

Sometime the sun can cause the sensors on the drone to get confused, just a thought.

what should i do if this happen? if i remember, switching to sport mode not helping at all, mavic still go to landing mode if push the stick left down