Peak Focus

[Lhemmerich]

the manual says...

Peak Focus Threshold: This adds red lines around edges to indicate focus. You can switch between off/low/normal/high these setting control when the effect activates.

I can not find this on my setup screen...see screen shot..

What am I doing wrong?

 

[msinger]

You can find that setting in the following section of DJI GO:




Make sure your Mavic is connected to DJI GO before attempting to set it.

 

[Lhemmerich]

Thanks..The manual shows this in Camera settings
I see its under General
THANKS,!

 

[msinger]

I see its under General

Which version of DJI GO are you running?

 

[Lhemmerich]

Which version of DJI GO are you running?

4.1.20

 

[msinger]

Interesting. I'm only able to see that setting as depicted above in DJI GO 4.1.20.

 

[Lhemmerich]

Found my problem...this setting needs the brone connected to show in go4.
When I connected it showed up...
Thanks for the comments
Larry