Hi everyone, yesterday I was flying and notice a strange behavior when I press the RTH button on the controller, the mavic was at 29m (95,8 ft) of IMU altitude and 49m (160,6 ft) from the home point, the Return-to-Home altitute was 40m in the settings, but when I press the button the Mavic start climbing without pauses and I cancel de RTH when it reach 65m (214,6 ft). I have a similar experience a month ago in very bright conditions, but at that moment the Mavic climb 10m, stop, try to return and detect the "obstacle" (the brigth ligth), then climb again and so on.
The user manual says:
"If Return to Home (RTH), including Smart RTH and Low Battery RTH, is triggered and the aircraft is further than 20 m from the home point:
1. It will return to home at the current altitude if flying at or above the RTH altitude.
2. It will ascend to RTH altitude if flying below it."
I take a look to the flight log (using https://www.phantomhelp.com/LogViewer) but I don't see any clue.
I use the DJI Go 4 app (4.1.4) and the firmware is the 0900.
Any idea of what happend? thanks.
The user manual says:
"If Return to Home (RTH), including Smart RTH and Low Battery RTH, is triggered and the aircraft is further than 20 m from the home point:
1. It will return to home at the current altitude if flying at or above the RTH altitude.
2. It will ascend to RTH altitude if flying below it."
I take a look to the flight log (using https://www.phantomhelp.com/LogViewer) but I don't see any clue.
I use the DJI Go 4 app (4.1.4) and the firmware is the 0900.
Any idea of what happend? thanks.