Hi Rob,
I found that closing the arm and lining things up was a better approach. I then took a set of broad thin square nosed tweezers and tensioned while turning towards the body allowed it to fall right in place on the first try. Keeping the arm tucked into the body made the process easier...
Hi Rob,
The tensioning seems to be my challenge. I have found that I can position the leg perpendicular to the side of the body, insert the pin, and see it just short of the frame hole on the opposite side. The two holes of the pin anchor are about an eight of an inch out of alignment to the...
I have had a crash that ended up snapping off the tip of the pin for one of the front leg Axis springs on my Mavic Pro M1P. There is a definite challenge to setting the new Axis in place so that the spring is properly loaded for opening and closing the front leg. Has anyone had some experience...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.