Recent content by AirBoudreaux

Agreed, however there were no actual flights. They were all tethered to the ground. The only "flights" there were were the tethered rides.

Had the privilege of shooting a hot air balloon festival a little over a month ago. It isnt a like most balloon festivals as they mainly set up on the ground, give a few tethered rides, and are mainly just for show. Anyway, we traded a sponsorship and a vendor booth for the weekend, for doing a...

Had the privilege of shooting a hot air balloon festival a little over a month ago. It isnt a like most balloon festivals as they mainly set up on the ground, give a few tethered rides, and are mainly just for show. Anyway, we traded a sponsorship and a vendor booth for the weekend, for doing a...

I’ve got a question about the use of watermarks. I know on some of the software that I’ve used (sketchfab for instance) the free version comes with a watermark and if you want the watermark removed, you have to pay for the subscription. I’m curious if anyone has used this model with their...

Decided to have them send it back so I could send it to DJI. DJI repaired it for free. Lesson learned! AWESOME customer service!

Oh yea, I could definitely see it being an issue then.

Roger that. I went ahead and sent in a repair request. Going to have Drone Nerds return the ac and just send it to DJI (as I should have done in the first place)!!

Yea, I know they (Drone Nerds) have some sort of mark-up. They have to make money too. Well according to them, its one unit and will all need replacing. This is what the email said. "DJI builds and calibrates their Gimbal/Camera system as a single replaceable part, therefore if the Gimbal...

So I've got to be looking at that wrong. According to that parts list, I'm looking at like $12 USD to replace the front arm and camera/gimbal module. Plus labor. That cant be right, can it? How can it go from $600+ to closer to $100 or so depending on what they find and labor costs??

So about 2 weeks ago I had an incident where I clipped a small branch under a tree. I had a yellow warning from behind me for the small tree. The base of the canopy was about 6' above the ground and I was about a foot under that. I wasn't directly under the canopy but apparently there was one...

I do mostly video and as long as I still have the ability to hold the Fn button down and zoom with the wheel, I'm good. Took me a while to figure that out with the Air 2S, so I know exactly the awkward movement you are talking about. Guess it would be nice to be able to pitch the gimbal down as...

Found a video that answers my question. The RC-N2 that comes with the Air 3 is upgraded with 2 transmitters now instead of one, allowing it to support ocusync 4.0 RC-N2 supports Ocusync 4.0

So I just purchased the Air 3 Fly more and I went with the RC-N2 controller instead of the RC 2. Main reason being that I currently use my 10th generation I-pad with my Air 2S and wanted to continue to use it as it is a much bigger screen. My question is though since the RC-N2 doesn't have the...

Got it! Thanks for your help! I was able to upload it to my website and I'm sure my clients will be able to do the same. That whole process was a LOT easier than I expected it to be in all honesty. Im sure this is just the tip of the iceberg with Metashape though. Do you have any other videos...

Ok, so I just zipped the .obj file and uploaded it and it worked. So now my question is downloading in a useable format. I normally share my deliverables via google drive or a 16gb jump drive. I have downloaded all 3 file options but none open to actually view the model. How do I go about...