I think part of it is the wind and another part is something being weird. My firmware seem up to date, but I did get a failure once I tried to update and then it showed the correct firmware. Couldn't revert the firmware on the remote to factory settings
I went on a bike tour for a few days where it was in my bike pannier. My bike is steel. It flew fine when I got it back for a few days. And then last two days just mag interference popping up all over town.
Something is for sure going on still. It's claiming there's extreme mag interference wherever I go. Can't calibrate compass at all....is it possible since this wasn't happening at these locations of flight before?
It's just red on the one compass and the other one is fine it looks like. But it does prompt me to move the craft. Anywhere I move it one compass fills up red. Grassy field, cement, its yellow when I lift it off the ground. Am I living on a iron mine?
I went to an open field and the compass is all in the red at like 1600. What's going on? There was never this much mag interference here? It's like everywhere I go today.
Anyone having these issues? Everything is calibrated -IMU AND COMPASS, had some mag interference in the morning but I fly low in this area around my house often. I have had this happen in open fields before too. When it does I bring it down and try again later.
What gives?
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.