Recent content by billru

Wanted to update, I finally got the gimbal to respond, the issue was me doing, somehow the pitch motor was unplug which made a open circuit. I am gonna recharge batteries then try to calibrate IMU,compass, visions and gimbal, I will update status for who ever is interested.

I finally can load the firmware to the latest or downgrade per DJI Assistant or the DJI4 phone app so the firmware issue is done but now I can not get the Gimbal to respond. I have 1)changed cables, (3 sets) 2)I have taking the gimbal apart 3 times, looked at cable connector pins under...

For those that are interested I believed I put the component's together for the Mavic 2 Flexible Signal Cable and Gimbal Motherboard socket Flexible Signal Cable MIPI CSI-2 40 pin connector on each end of Signal Cable DF56-40P-SHL 15 pin connector on cable to Gimbal flex cable...

On the top side of board the 40 pin that I am looking for supplies the camera and Roll motor, the one on bottom(16 pin) goes to the Core board then on the other side of the Gimbal main board is another 16 pin which goes to the Yaw motor

Its at the top, its the signal cable to the camera(40 pin) its 20 pins then a gap with another 20 pins after gap

Looking for input on the camera signal cable connector on the top of gimbal mainboard pictured below, dose anyone any of (name, type, PN or where to find it). thanks

Well I am having a devil of a time getting it to refresh firmware, I have uninstalled, cleaned registry then reinstalled Dji Assistant & Drone hack, cleaned the cache on drone, changed the com port Baud rate and can not get pass 20% in either, program. I am gonna try again today and I'll post...

Thank you Fizzbang for the reply I have a couple of used Drones that I brought, one supposedly hit water the other had a crash, I have taken both apart and all looks good, I reassembled with new cables then powered up(The drone powers up, beeps and the light light up) but got no gimbal...

I am new to all the drone worlds, I brought a Mavic 2 for parts and I would like to try refurbished it so I can learn the workings on this drone, I have been reading and watching videos but I ran across something I can not clarify so I am hoping someone here can help. I have read that with the...

I answered my own question, I was able to find a Mavic Gimbal and its smaller then the Mavic 2 so no the Gimbal motors will not interchange

Can someone tell me if the gimbal motors of a Mavic 2 and a Mavic are the same or different,

Thank you for the reply

I am still learning the ins and out, are the 4 motors the same (neither clockwise or counter clockwise) and when they are connected to the ESC, the ESC is what powers them clockwise and counter clockwise

Thanks for the link, that is exactly what I did, I dug around yesterday and found a glimpse of a photo where the tabs went and after studying I was convince I put them in the right place and thanks to your video link it confirmed where I installed them. Thanks again

I think I figured it out, once I assemble the gimbal I'll update with a photo