Recent content by brioni99

When checking if firmware was up to date from the RC I was getting a Yes (for both the drone and the RC). I connected the drone to Assistant 2 and received this message: "Firmware incompatibility detected between some modules and current device. Update your firmware?". Updated through Assistant...

So, after a factory reset of the RC and some more flying tonight, I'm fairly confident to say that what causes those freezes is gimbal movement. As long as I don't move the gimbal, the RC is responsive and works as intended. However, if I moved the gimbal during the shot, the record button (both...

Thanks guys, I did a factory reset of the RC and will go on another flight today to test if it improved anything

I went for a flight today and had the shorten the session because the RC was barely usable. It sometimes took more than 20 seconds to register inputs such as start/stop a video, rotate gimbal, change shutter speed and exposure, etc. The flying (stick inputs) was unaffected. Lag and...

Update: Sent the drone to DJI and received it back today. I was surprised to see that the prop was still not moving freely! DJI did untighten the screws though. So I took the prop off and found out that the rod on which the prop is mounted had a thicker "ridge" towards the top, brown ish color...

I'm french and do not feel offended the slightest by what he said, the red zones really are ridiculous in some places

Ran a test today - pretty happy with the results as I was able to push to 2000m while maintaining a strong signal. Didn't go further because I don't foresee a real life situation where I'd need to fly that far

The drone flies perfectly, because the prop gets in the right place when the motors start spinning. Haven't noticed any weird behavior once it is in the air (granted I'm a new pilot and maybe a trained eye would spot something) Anyway for peace of mind I'll have DJI exchange the drone

So update on this I talked to DJI yesterday and they advised for me to wait on the better screwdriver to arrive, and if I still couldn't move the screw then, they'd replace the drone under warranty I did fly for a few hours already, what's your logic though, it would be concerning if the...

Thanks, I'll ring DJI tomorrow and see what they offer. Bummer having to wait for another week but it is what it is

Hello folks - 1st message here. I received my Mini 3 Pro yesterday and upon inspection one of the propellers is screwed on too tight, meaning it doesn't move if I giggle the drone in my hand. I don't think that's a problem for flying because the centrifugal force is enough to move it in the...