Recent content by Brutus82

Have you worked out how to remove and replace the motors individually rather than replacing the entire arm?

I was hoping of some kind of tet ring similar to what is available for testing the signal cables. Still haven't worked out a good way of removing and replacing the individual gimbal motors.

Does anyone know how to easily test the gimbal motors on a Mavic 2 Pro? I've repaired a few units now for friends but it can take a while if you have to disassemble and assemble the entire gimbal unit to test each time via process of elimination. Welcome any help on how to make a test rig.

Previous owner did that on the one I bought...didnt realise. Can't fix it.

Any idea how they fixed it? Wasn't a core board replacement..?

How did you fix it? I've had the same issue but can't reformat.

How did you go with this? I've had the same issue.

Correct. There will be a solution as it would be the same fix for a USB fault but you need to know specific details regarding manufacturer of that specific part..... Doubt DJI will give any help other than send it in and replace it......for something fixable...... Grrr.

Nope unfortunately not, it doesn't work, says not found.

Not sure that it is......likely soldered to the board in the Mavic 2 I'm assuming?

Unable to, doesn't recognise it. I think the person that I bought it off may have formatted the internal storage using their PC in NTFS format based on what they have told me.

Hi, got a Mavic 2 Zoom and it isn't showing the internal drone storage as shown below for Removable Disk D. It is showing as No Media within Disk Management on my PC and I can't work out how to fix it. Anyone else had this issue and been able to resolve it?