We’ll, I’m going to replace the motherboard, with no movement whatsoever on the gimbal, I think when the ribbon cable melted it screwed up the gimbal plug.
Just the gimbal, ribbon cable and camera cable. The old ribbon cable was melted. It left a stain on the motherboard. All the pins for the plugs look good. I’m getting good pictures and video from the camera.no movement at all from the gimbal. I am hoping the gimbal needs paired to the...
I watched this earlier, I still don’t know if the new gimbal needs paired. I am getting the unrecognized error and limp gimbal even after I send the dos command with python.
Thanks Cafguy
I purchased a mavic air 2s that had gimbal problems. The ribbon cable was burnt. I replaced the gimbal and now it is limp.
here is the Dos screen:
C:\dji>py comm_og_service_tool.py --port com3 WM232 -vv GimbalCalib JointCoarse
Opened com3 at 9600
Info: The Gimbal will move through its boundary...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.