Recent content by CraggPilot

I recently crashed and bruised the nose piece on my M2Z. I was able to get the replacement piece, but am having a tough time trying to take off the damaged piece. There are only two screws that seem to hold it on. I removed them, but tug as I might, it won't come off. Is there another piece...

I sure hope that DJI realizes that this is a common issue and comes up with a firmware fix. I came close to returning my MP2 Zoom but did not because though I had the “Poor Signal” light, I still have better range then my Mavic Pro...I figure this must just be an ultra sensitive signal strength...

I did try turning off WiFi and switching channels, picking a lower, more distortion free frequency etc..with results that were only very short lived ie.Showed good signal until it left the ground. I did however fly it yesterday 3 1/4 miles away with the poor signal light on the entire...

No...no crashes, bumps, hard landings or anything...has been pampered. I did however download the new firmware when I got it thru wi-fi instead of hardwire. I have since redone the new hardwire firmware upgrade and hasn’t made a difference. I also linked the new RE edition DJI goggles with...

Thanks for all your input.........I’ve only had it a week and it doesn’t seem like it’s normal....are any of you experiencing this? It says “good signal strength” for 30 seconds when starting it up then switches to “poor” and stays there. I have flown it 2 miles away out in the country then...

Thanks for your response Meta4. You say I can switch between frequencies manually if I’m having a problem.....but this issue happens when the controller and Mavic are only a few feet apart from each other and are in the “auto” frequency mode. It fires up saying “good signal then switches over...

Were you able to resolve the issue? I installed the new firmware when I got it, but did it with WiFi instead of hard wiring it to my puter.....was told this might be the problem

The signal quality switches from good to poor within a minute after firing up and stays there....this happens in all areas in town and in remote areas.....Please HELP!!