Recent content by dataflurry

Never mind, they only have them for storage (which may not be a bad idea).

Is it safe to put motor covers on, or would that risk burning out your motor from over heating... I am guessing its too risky since im sure those little engines get hot

Yeah I took the 3 screws off and blew it out (holding it upside down) with an aeresol can. Must not have been metal. Seems to have worked, no more major noticeable issue - but I am going to fly it low for 30 minutes or so tomorrow. Seems like its working (cross my fingers). I am going to try...

Surprisingly the system says ready to fly (obviously I am not going to). It was a broken drone and I just put on a new camera and new GPS unit, but the drone was flying with absolutely no problems just a week ago. But can you guys take a look at this video and offer recommendations? Also how...

Great, ya I hope so I think Thunderdrones would know.

is there is there a diagram that shows where each motor is located? Analysis is telling me motor 3 is out. I need to buy a new arm with motor but want to make sure I replace the right one

Thanks I want to just grab a new arm but I don't know if the arm alignment is the same as the phantoms or if it could be different. hoping someone can tell me which arm number 3 is so I can just put a new one on and solder it together

I'm starting to gather that I'm starting to gather that he knows everything mavic

Does anybody does anybody know what arm motor 3 is attached to I can't find it

anyone know the dimensions and thread pattern of the screws? I am trying to obtain the top cover (shroud) screws for 3 different mavic units (so 18 screws in total)

Ok, I can't find the screws for the mavic pro anywhere. Has anyone been able to hunt down screws anywhere? Also, are there any aftermarket gimbals that aren't $350 that work? I need to entirely new assembly's