Recent content by DroneObsessed

I want to test individual motors on my Mini SE. Probably not, but is there an app/program that lets you start/control individual motors for this drone. Nothing is wrong with the drone, but i kinda want to play around with it. Thanks!

Thank you for the feedback. I have edited my comment to use this info! Thank you so much.

Do a IMU calibration and compass calibration. If that doesn't work, get a small amount of masking of duct tape and stick it on the sensor. Be careful as the drone won't know it's exact altitude.

I will be sure to do that from now on. Thank you for the help.

Thank you!

Thank you so much. If I remember correctly, it was rather dark. It was the afternoon (around 5pm) and the sun was bright, but the yard was shady. Just one question, what app did you use to make the stick inputs and responses? Is it in Airdata? Again, thank you so much for the help.

Unfortunately, I was paying most attention to the drone in real life, not the screen, but I believe it said Signal Interference, so I have a strong suspicion that has something to do with it.

I'm pretty sure that is because I shared the file and turned off the coordinates for privacy reasons. If I remember correctly I had 8-10 satellites. Thanks for the reply though!

So yesterday, I was going to fly my Mini SE around for a bit. I did a manual takeoff, but it appeared to take much longer than usual to takeoff. I didn't think much of it until I pressed the left joystick up to make the drone go higher, and it didn't do anything. Out of instinct, I also pressed...