new battery arrived and in charge...but... after one week of self discharging (48%) i did a new test with old battery... surprise!!! 4.27 4.24 4.27 and fly good!!!!
now discharged hovering to 5% and recharged, ok tested ok... i will keep as spare battery....
soon test the new one...
if with new battery all ok i will buy an ac adapter for old battery and use it as power bank... should be after few discharge it will be ok .(i did it one time only with mavic on the table for 30 minutes to 5% but i dont think is best way... the drone is boiling with no real wind)
i know... just strange (as usual big coincidence) after last update of firmware... (every single time i had to do a firmware up date... some strange happened)
from 2017 one year
first update - difference in dji to go... doesn't fit telephone screen any more
second update - lag in the video on...
today..ready to test drone after gimbal rplacement!!! so happy!!! but...
after start... battery error!!!
it says cell defective repalce battery
if i go inside menu i can see voltage 4.2 3.92 4.2
all LED on stady
100% indication on battery status...
very strange but i have no other battery for...
yes.
yes... i did ... :eek: i have impression now the system has no more reference for gimbal tilt position ... no way to fix? just replace all ???
thanks
Hi
any one knows what are doing the screw in the center of gimbal motors? (after crash and ribbon replacement , i tested drone and was ok a parts one angle of gimbal tilt, so i decided to unscrew one of the screw ....and then is not working any more...)
any idea what the screw function is and...
installation done, damper board and flat cable (ribbon) ... very difficult to put cable in correct way. any how... is working but... gimbal vertical movement is blocking in one position and only if you touch very gently with finger is passing that point... so i m not sure if my installation not...
i found on internet liquid tape (black)
but this is the one used on the connectors
still i cannot find the one used on the flat side of ribbon to fix on different part of gimbal
so... after crash...and gimbal motor overload... i deciced to start investigation (using youtube video as tutorial) i found gimbal flat cable or ribbon broken...
at moment waiting new one.
any suggestion on with glue to use to fix cable on arms and plug?
thanks
any upd
ate on the glue you use? also the ribbon is fixed in some point on gimbal arms (with trasparent glue) did you reach th replacment? i have ordered my new ribbon and dismounted the old... just guessing with glue to use....
yesterday i did a very idiotic error... start fly and recording without taking a good look around (and on top...) and after 270km of good fly i destroied my Mavic....
at 14m from floor i impact with last part of a tree!!!!... i was so concetrated on recording that when i see the tree on the...
DONE!!! FIXED!!! it is the APP!!! now also the dear old samsung S3 is working perfect!
app version 4.15 !!!
if i have time i will try opposite way... install last firmware on MP and RC and check again... just for interest!!!
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.