DJI Mavic, Air and Mini Drones
Friendly, Helpful & Knowledgeable Community
Join Us Now

Recent content by gantarone

  1. gantarone

    Gimbal Not Respond to Remote Controller (pitch up/down,calibrate, Reset Setting Timeout) MAVIC 2 PRO

    SOLVED !!!! the ribbon cable from the motherboard to the Motherboard Gimbal was broken !!!! It was like I thought the TX wire (CAN or SBUS) was broken,so the command transmission did not send to the Gimbal and I had on the RC "timeout" message 15 $ and everything is back to normal ...... I hope...
  2. gantarone

    Gimbal Not Respond to Remote Controller (pitch up/down,calibrate, Reset Setting Timeout) MAVIC 2 PRO

    yes I calibrated the remote control, while the calibration of the Gibal I did it with the commands via python. The remote control does not work the calibration, when the launch nothing happens
  3. gantarone

    Gimbal Not Respond to Remote Controller (pitch up/down,calibrate, Reset Setting Timeout) MAVIC 2 PRO

    Maybe but while he was at 40 meters and descending at full speed he touched the ground and rose 11 meters ... (spring effect) At the moment what interests me is repairing my Mavic. Anyway below there is a table of the last flight with Hard Landing Gimbal Roll Reached Movement Limit Flight...
  4. gantarone

    Gimbal Not Respond to Remote Controller (pitch up/down,calibrate, Reset Setting Timeout) MAVIC 2 PRO

    Thanks for your helps, 1- I tried again to do the calibrations, I don't have any kind of hardware error (Still the same). 2-I tried to Downgrade the remote control and Mavic, also tried the upgrade (Still the same). 3-deleted the DJI GO4 application reinstalled and deleted the internal...
  5. gantarone

    Hello everyone from Italy Tuscany

    Thanks!!!from the hills of Florence!!!!
  6. gantarone

    Hello everyone from Italy Tuscany

    I live in Tuscany(near Chiantishire), and I love traveling around Italy and taking pictures with my Mavic 2 pro I am not a photographer, I am passionate about drones i hope i can contribute this site and maybe help someone. Ciao
  7. gantarone

    Gimbal Not Respond to Remote Controller (pitch up/down,calibrate, Reset Setting Timeout) MAVIC 2 PRO

    HI All, After Hard Landing (due to the sensor seeing negative altitude)VERY DANGEROUS!!!!! Gimbal which works OK during Startup (X Y Z movement, stabilization works correctly) but does not work with the Remote Control when I try to move Camera UP/DOWN or LEFT/RIGH When I try to reset the gimbal...