Recent content by iliasp

Hello, Any news on the infrared sensor recalibration? Thanx

Hello, I replaced the bottom board carrying the infrared sensors plus the upper ones and now i get two errors which wont go away no matter if i recalibrate the vision sensors any idea how to fix this?

Thats a bummer There must be a way to software calibrate them and get rid of the errors by the time everything is fine now like the gimbal calibration method found over here if thats the case i suppose indy repair shops are out of luck just by simply replacing a vision related board if anyone...

hello, any updates on this one? i have replaced both sensors (upward infrared plus the vision ones and board, also downward with a new board) and get this error no matter how many times i went through the calibration with Dji Assistant on my mac

Lots of IPA (I mean liters), baking soda, brushes, ultrasonic bath, a microscope, some new parts (2 motors, gps flex cable, imu, esc board, camera flex cable) and a little bit of quarantine time It seams solid for now, i have been through 10 battery cycles and everything runs as it should

well after two months of working on this lemon, i made some lemonade, it still has a lot of footage to offer ? only the camera left to assemble and weare good to go https://gofile.io/d/7O6N1d

not at the moment

Everything is here with me, all taken apart and thoroughly cleaned

Spent some time in the Aegean sea, left like that to dry off without washing out and eventually became a lemon

Did i hear something about ??

Do the motors rotate easily? All three of them

Sounds like the cooling fan, If the sound changes when it gets hotter and rpm are higher then 99% is the fan

I dont even have a led blinking I found the problem and will be starting a new repair thread

If anyone has any idea in the issue it would be bice to share it! I am having exactly the same issue, drone is out of warranty unfortunately

hello, i am having the same issue! Any update on this? Thanx in advance