Recent content by jaymc

Also, I would cancel the sold drone if it's registered with the FAA

I used a label maker, and for added measure, covered it with clear nail polish.

iPhone 14 Pro, but mostly use the DJI RC. Using the iPhone 14 Pro just for the brighter display and to check when it dims when heated.

Also, ensure to only buying Sandisk memory cards from a reputable source...a lot of counterfeits out there.

Maybe the publisher could have run the book by someone who's ONLY language is English and likewise to other languages as needed. See the pic for page 130 of my review as something easily seen by someone who only knows English (labeled Libero mode vice Free mode in both table of contents and page...

Did write a review ... my biggest contention is that the book was obviously translated from Italian to English and sometimes the translation didn't go as planned. Otherwise, an in-depth guide for the mini 3 pro.

Thank you so much for your reply! I do plan on never flying beyond VLOS since that is the rule here and in regards to learning the ins and outs of the mini 3 pro, I purchased this book on Amazon; very good reading!

I just use a white dish towel - knocks down the grass, helps keep out dust and if I need to change a prop, helps to not lose screws.

Everyone says to "not over tighten" when screwing on props, including DJI maintenance support. In my previous job in the manufacture of torpedoes, no screw was screwed down without a specific measured torque. Question is, is there a recommended torque value for the mini 3 pro? Is type of...

Owner of a DJI Spark (2019) and now a DJI mini 3 pro.