DJI Mavic, Air and Mini Drones
Friendly, Helpful & Knowledgeable Community
Join Us Now

Recent content by kaizenie

  1. K

    Mavic Pro - Gimbal motor overload even after changing ribbon and gimbal arm

    Check if you have the same level indicator as me which might indicate a broken sensor in the camera part:
  2. K

    Mavic Pro - Gimbal motor overload even after changing ribbon and gimbal arm

    Just about to pick this up and give it a try. I received the information earlier that it might be the sensor inside the camera lens: Anyone that can confirm this?
  3. K

    Mavic Pro - Gimbal motor overload even after changing ribbon and gimbal arm

    Hi, did you fix it by changing the control board?
  4. K

    Mavic Pro - Gimbal motor overload even after changing ribbon and gimbal arm

    I would really appreciate if I could get some other suggestions on this
  5. K

    Mavic Pro - Gimbal motor overload even after changing ribbon and gimbal arm

    Thank you so much! Yes it contained both motors and cables. I just used my camera from the old arm and have the same issue as I had before doing the procedure. Prior to changing the whole arm that came with a new ribbon, I tried changing only the ribbon itself.
  6. K

    Mavic Pro - Gimbal motor overload even after changing ribbon and gimbal arm

    Thanks for your reply! I replaced it already with this part, but the problem remains: https://www.ebay.co.uk/itm/DJI-Mavic-Pro-Drone-Gimbal-Camera-Arm-with-Flat-Flex-Cable-Repair-Parts/233162831237?ssPageName=STRK%3AMEBIDX%3AIT&_trksid=p2057872.m2749.l2649
  7. K

    Mavic Pro - Gimbal motor overload even after changing ribbon and gimbal arm

    Hi great folks, I got the common "gimbal motor overload problem" (as so many others) on my Mavic Pro (v1). What happened is that I had a hard landing on sand. Everything else seems to work fine though, the drone flies but the gimbal doesn't work. I tried repairing it by changing the ribbon and...
See more