Recent content by Lebensgefahr

I've tried to downgrade dji rc firmware with a little hack through the dji assistant 2 (consumer drone series) but failed. It was failed after "Transmitting" part of the updating process on Updating 3% stage. So now you can't downgrade dji rc firmware if 01.03.0400 installed.

Hi. My RC is not booted normally. If I connect usb adapter to RC it's status led will not on. But my second RC will. That means kernel module is not loaded because there is no loaded kernel. In flashing leds mode RC receive video signal so you can see the picture but you can't transmit any...

Watch this video I just want to warn you that works only adapters based on ASIX old chips. For example DLINK DUB E100 adapters. Of course I am not sure they are using openwrt but I found default TPlink password in the shadow file. Moreover RC based on the same chip as one of the TP link...

Hello. It is not possible because RC is not detected by any kind of operational system. It can't start linux kernel and as the result it is not available as any suitable for A2 device. I thought that should be serial port somewhere on PCB. But I didn't find it. That means RC is totally bricked...

I compared file system dumps in this two modes and there is some difference in one file /etc/fs2/log0.txt. On the left side of | is normal mode. Left of < are missed strings in the flashing mode log. Update ok flag:0 Update...

I've got the answer from the DJI support. May I know where you see this mode? Please offer me an image of it for review. Actually, there are no button combinations for Mavic Mini. I found some leftovers of TPLINK routers in RC firmware. So it is possible that they are really have no thoughts...

I checked all of the pins on the main board, buttons board (not under the chip covers) and nothing. There is no rx/tx pins. How did they flashing it at the factory... It should have an easy access to its serial. I checked all pins of the ribbon cable. It has 10 pins of GND, 10 are connetcted to...

Yes you just need to turn it off (powering off without sound) and turn it on again to get into normal mode.

Another part of photos.

I don't see any pictures in you post and I don't know why. Maybe some restrictions.

I disassembled it. I didn't find something looking like serial port. I checked all of the points on board and nothing. I discovered that there is a place for the button on the main board but it is not soldered. I checked it and it looks like it is the second power on button. I can turn it on by...

When I connected RC to USB port of my linux PC dmesg shows me the following. [71426.174449] usb 1-3: Manufacturer: Linux 2.6.31--LSDK-9.2.0_U11.14-g580e8c6-dirty wi #this kernel is in the RC firmware. [71426.208962] cdc_acm 1-3:2.0: ttyACM0: USB ACM device [71426.210414] usbcore: registered new...

When I connected RC to USB port of my linux PC dmesg shows me the following. [71426.174449] usb 1-3: Manufacturer: Linux 2.6.31--LSDK-9.2.0_U11.14-g580e8c6-dirty wi #this kernel is in the RC firmware. [71426.208962] cdc_acm 1-3:2.0: ttyACM0: USB ACM device [71426.210414] usbcore: registered new...

Not braver but more stupid :)

What doesn't kills mavic makes it stronger :-) In this mode RTH button is not working, but I think it will work OK. I will check it ASAP. I will do it in a close distance to me to have full control. I'am expirienced air vehicle pilot (helicopters, plains, quadrocopters without GPS).