Recent content by Lee Snook

Is there a way to have the camera start in AED mode, 5 exposures upon power up? I don't want to reset the camera to a particular mode every time I power up. I know that it uses the last mode set for the previous flight but it starts in 1 shot mode not AEB 5 exposures.

5 HDR images stitched together with Panaview Image Assembler. Each HDR image is 5 bracketed photos merged using EasyHDR. The Pan image was then put into my video editor Cyberlink Power Director timeline, generated a .mp4 still video. Reinserted the still video onto timeline and cropped 16:9 and...

One thing that I found was when I am panning and tilting at the same time, it has a tendency to skip frames.

Thanks, nice job for starters! Suggestions, as the previous poster stated, keep ever clip short, 5-10 seconds is what I try for. Total time, I try for less than 3 minutes. My person taste, the video needs a little more contrast and brightness but otherwise you seem to have very good control of...

I had this happen to my old phantom 2 a couple times. I had other WIFI devices running nearby, this could have been the problem. I turned off my GoPro, Phone WIFI, and any other WIFI devices and seemed to correct this drifting off and crashing.

My preference is to turn On Over Exposure warning in the camera settings. This will overlay Zebra Stripes in over exposed areas of the image viewed on the monitor when flying. Adjust the right thumbwheel so that the sky or brightest areas show some zebra stripes. If you are flying in different...

What was your rth altitude set at? Always try to set mine much higher than any object on the return path.

Very nice, good video!

Have flown over 200 flights with NO crashes yet. Amazing machine. Only occasion uncalled for gimbal movement. But, today the gimbal started to shake and move around erratically for the balance of the flight. I was not touching the gimbal controls. I installed V001.04.01000 firmware this morning...

1. Occasionally, my gimbal jumps up and back down again. I am not touching the gimbal wheel when this happens. 2. I get a jump in frames occasionally. Both of these problems are depicted in the following video. The frame jumps occurs at about 4 seconds and the gimbal jump at about 5 seconds.

I have experienced "Spinning" with the forward object detection on while facing the sun. For some reason, lost connection to the controller. After a few seconds, the mavic tried to RTH. It stopped, increased altitude, increased altitude again, then started spinning, about 3 times. This repeated...

I have the gimbal tilt speed at 7, and the tilt Smoothness at 20. It seems as if the tilt to the up control is much faster than down. Has anyone noticed this? Another problem, when panning and tilting the camera, the video skips frames or jumps.

What methods are available for setting the proper exposure when using the goggles. Since the goggle don't have a histogram or over exposure lines, how do you determine that the image is properly exposed? When using a tablet, I can press the C2 button on the controller for center exposure; Even...