There are two buttons on the back of the controller and the top left button with the red circle on it are correct?
The controller does not beep when I press the "linking RC" on my connected phone.
First method: Everything is dandy until I get to the point where I have to press the button above the little LED. My LED is green while the one in the video is RED. Furthermore, when I press the linking RC button, nothing happens.
Second method: I get no beeping when holding the back two...
Good point...
I guess I will take my chances sending it off to DJI and hoping they cover some or all of it. I was hoping for a quick fix or way to test the issues on my own to diagnose the issue.
Correct, WIFI works, RC does not.
How difficult would it be to take apart and not break anything else for a mechanically inclined guy? I have tried binding again with no luck. Yellow light flashes quickly on the back but the light near the SD card remains GREEN (not red???). Very strange...
I would agree with you typically but there is absolutely no visible damage and the ribbon connection is still okay. It also moves on its own and goes through all the motions without problem but then the notification comes up...
Looking for some guidance... As I was flying my 3 week old Mavic Pro (on firmware 0400) the joysticks stopped working as if I had lost connection. I was in GPS mode and about 70 feet from the AC when it began to slowly lose position and hit a branch of a tree. It then played around in the trees...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.