Jimmie,
I crashed my MM pretty hard and ended up replacing the core board, gimbal motor, every ribbon cable, and other parts. I ended up with the same codes in your post. I contacted DJI support and told them about my repairs and asked if they would recode it - they said they would, but I did...
No care refresh, and definitely my fault on the crash. I have another MM and it is up and running, so I may shelve this one until I can figure out how to pair the two boards. Lesson learned - I'll get the care refresh on the next one for sure.
Thanks for the reply!
Until today, I have not been able to power the MM. After changing the main board, I was able to power on - no camera feed and the gimbal is malfunctioning (only moving in certain directions and will not recenter past 10%). Laundry list of errors:
10001 - Camera...
Agree, the main boards with the vision sensors seem to be relatively fragile in terms of moisture and impact. If you replace the main board, which is expensive, you will still have to send it to DJI to have the main board recoded for use with the gimbal. I’m not even sure that DJI will service a...
I did a pretty good job of crashing the Mini. after the crash it failed to power on and I replaced the main board. I am able to power on, but still have a downward sensor error that cannot be cleared to take off. Additional details:
-Gimbal was completely dislodged from MM. Installed new gimbal...
Hi all,
Crashed the mavic mini and popped the gimbal out and tore the gimbal ribbon cable. After crash, still had power to the MM and received down sensor error and gimbal error. Replaced the gimbal ribbon cable and remounted gimbal. Now the MM will not power on - I have tried with 2 different...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.