Recent content by quaddicts

I know it's magnet sensing but why the Right stick works on the left if there is some magnet failure and the left won' work on the right? I even changed the Right dial board with a genuine DJI part still no response on the right. That's the fixed that made my RC works and I tested it a while ago...

I'm the original owner, well taken care of, 2 years of casual flying when I travel. I got lucky, I fixed it by spraying all the contact points and now it's working. Will test fly later and update if it still act up.

Thanks for the reply. After a sleepless night and countless trials cleaning all the contact point in the circuit boards with a quick dry electronic contact cleaner (I sprayed about 5x) I finally fixed it. I believe those dust that accumulated over time was the culprit. I calibrated the RC, dials...

I have been dealing with this issue for a couple of months now, "STICK ERROR RE-CENTER CONTROLLER". RIGHT stick won't move on calibration LEFT stick works fine. Seems like there's no fix on this issue so I opened the RC, swapped the R stick to the left board vice versa. The R stick that was on...

Mine start acting up too. Neverending beeps, I tried to calibrate but right stick doesn't have any single response. I tore down my RC, swapped out the sticks, right on the left seems working left stick on the right no response therefore it's not the stick causing all this mess. I ordered a right...

Here's mine. kapay ako

The reason I got the Litchi 'coz my ipad 4th gen is not compatible with the DJI go4 app, I think I love litchi now.

I have a Litchi installed on my iPad 4th gen, it works fine, I'm using an updated Litchi. Just purchased 3 days ago.

Thanks for all your replies, I can now have a peace of mind, take a seat and drink my espresso.

Is the props in the pictures normal after landing? Does anybody here has the same experience in flying with their low-noise props? TIA

Flew earlier with my new low-noise props but after landing it seemed like it was misaligned is it normal or not?

"Will the controller discharge if powered off and side connected to a phone (your scenario, but controller off)?" To answer the quoted question, the answer is No, I just tried it today and it only charges the phone when the controller is on and tethered.

Upon exploring my Mavic Pro controller, I found out that if your phone is connected on the side port of the controller it eats a lot of charge because it charges your phone but if you connect your phone in the lower (bigger) USB hub/port it won't eats up the charge but make sure to disconnect...