Recent content by robwag

Hi KI5RLL, if you want you can see all my Cape Town area Drone, Osmo and GoPro recordings, here is a link to my Utube. Unfortunately I do not have any with Great Whites in them yet. youtube.com/@robwag007

Hi Terry, look at 3:30min I noticed the rocks were getting closer and stopped and turned and looked to my left and found I was within a meter of the rocks. You are right it is not edited, I do not have programs or brains that can do that.

Hi Monte, it is called Hallelujah, here is a link, Robert

You were lucky to find it again, talking about flying sideways look at my video. it is very difficult to judge the amount that the rock surface goes in and out going sideways, the side sensors are one thing I miss on my Air 2s.

I have never heard of charging in the aircraft. All my Phantom 4's, from standard to Pro Plus, Mavic 1 and 2 Pro and now my Air 2S is not capable of charging in the aircraft.

Many thanks

Hi guys, I was wondering if it is OK to recharge your half flat batteries, or is it better to run them flat before recharging ? What is best for the batteries life ?

If you have updated past 02.04.2080 this might not work. Go into your settings and look for the section to allow you to see the software mode section. If you cannot find it ask one of the moderators they should be able to help. Follow this link below...

@Agustine I managed to get the speed down on the simulator, but as soon as I switch the drone off and then on again it reverts to the old setting. If I just unplug the computer and leave the drone on then I get Cine speed down to what it should be. It does not seem to be saving it to the...

No, learned about that very soon.

No, not a design flaw, just a few numbers wrong in the software for Cine mode.

Tried: https://mavicpilots.com/threads/slowing-down-cine-mode-on-the-air-2s-5-mph.115526/ The slow cine speed is saved until the drone is turned off and on again. If the value is changed and immediately flown then it is fine, but not once power cycled. Any idea why it would keep resetting to...

I have adjusted the exponential rates for sport and normal but there is no adjustment for cine.

Hi, I have not been on this forum for long so am still a bit doff, how and where do I ask to join the firmware modes section? I have looked all over for something but do not see it. Many thanks.