Recent content by Rocketramo

Just one test proves nothing. You should repeat the test at least six times in succession. swapping the blades over to the opposite battery each time. I noticed you spun the Mavic around into different positions, that shouldn't have been done either as your adding in extra inputs. But thanks for...

Or indeed a long pole and Gopro.

Throw away your guns and buy a big net.

All my old and obsolete electronic devices seem to end up in the loft, just in case!!! At least I'll be able to fly my old mavic up through the hole in the ceiling instead of struggling up the steps.

Am I missing something. Could you not let it fly a few hundred yards away, let it hover, and then turn the controller off to check the RTH?

Thanks for all that. You've read my mind. Love a glass or two of the Islay malts. And Arran is also on my itinerary. Probably wont be flying much above 100 feet above ground level anyway, so I'll not be a problem for them.

Hi Callum, I'm thinking of coming up to the west coast of Scotland (Islay, Jura, Skye & Raasay) in the spring. Can you give me more info on these low flying timetables you mention?

I have had to do this a few times. It must be quite normal for the drone to warm up. Mine starts a cooling fan after a while. Hope this helps

Sorry. My fault. thanks for pointing that out.

Has anybody had any experience of these cheap props only £2.73 for 4 on ebay from China. Just wondered if they are any good? Low-Noise 8331 Quick Release Propellers for DJI Mavic Pro Platinum Edition New

Very interesting to read about these problems. Can I throw in my un-scientific thoughts. How about radio interference. The ether must be full of radio frequencies, Taxi radios, electric motors, CB radios, wifi, even lightning. OK they should all be kept well apart, but I'm old enough to remember...

Thanks Thunderdrones for that, tried what you suggested, but first I reset the firmware back to factory settings and then re-installed the latest updates. But the same happened. When the drone and controller first connected it said straight away that it was ready to go. and I got a green light...

I'm a newbe here and not sure if I'm doing this right, but I'm having the same problem. Just bought a new Mavic Pro and every time I start it up from cold I get a Controller warning saying "SYS WARNING check app" The app says first "IMU parameter error Hardware malfunction contact DJI support...