Recent content by Roy.

There was an issue a few months back where the gimbal tilt speed would only respond to what was set in N mode, the workaround was to set obstacle avoidance to "brake" instead of "bypass". Test it in flight.

I have the same issue on one of the M3 Pro standard props fitted to the drone, noticed it yesterday in bright sunlight.

$900 for a used controller isn't quite what I had in mind, I'd still be sitting on the fence if they were half that price, especially since knowing my luck it'll probably be superseded soon after I bought it, hence my original question.

Do we think the RC Pro will be replaced any time soon? I've thought about buying one but I'd rather wait on the next iteration of it before splashing out, I'm put off by the weight and battery life of the current model, and of course the ludicrous price when compared to the much better value DJI RC.

I bought the Anker powerbank linked in post 1, I just charged a Mavic 3 battery from 15% to 100% at 100W, there was 18% remaining in the powerbank, enough to give the RC a good top up. The powerbank also charges itself very quickly, can support 140W input/output. But what I didn't expect is that...

Ebay

Nonsense, I was doing it all day yesterday. Skyscope is correct, even when filming in Pro video mode, if ISO and/or Shutter and/or Aperture are set to "Auto" (yellow) then the tap and hold function (and I presume RC button assignment) to lock AE works fine. Check this by tapping the vicinity...

Made a surprising discovery today, the Anker's 60W USB C is able to charge my Mavic 3 batteries using the 100W charging hub which was supplied with the Mavic 3 Pro fly more combo, it charged 4 batteries and still has 23% remaining, If I'd done this via the Anker's inverted AC outlet it would...

I've just tried it and it works in pro and auto camera modes on DJI RC, tap to focus to reveal the yellow square, then hold the yellow square to lock AE.

Thought I'd share this video I watched on YouTube.

I think tapping and holding the screen locks AE.

Is anyone else's showing up in DJI Assistant 2 as "WM261" instead of Mavic 3 Pro?

I'm not convinced it's exactly the same plastic as my old Mavic 3, the 3 Pro feels very slightly different to me, I could be wrong though, also noticing the fan sounds slightly different, all I've done so far is update firmware. Btw is anyone else's showing up in DJI Assistant as WM261 instead...

Thanks for sharing this.

What are these tried and true methods and practical tests?