Recent content by S.N.U.F.F.

They work fine with my Mavic 2 Pro. I did the upgrade to R1.5, no problem. Just make sure video caching is off in DJI GO.

My box seals also looked like previously opened but the unit works fine...

I like this combo. I had about 10 successful flights and one unsuccessful, but that was my mistake. I did not shut down the moverio properly, the battery went flat, and the remote was unable to charge it while flying. So it kept rebooting...

Not while charging, I hear a high-pitched hiss regardless volume level. Like a bad grounding. Is my Moverio defective? Also, the recommended App to view Youtube 360 videos is showing them too pixelated and with sound starting to stutter after a few minutes. Is there a better app, maybe to view...

Then it looks like a bug to be fixed on Epson's side! @EpsonMoverio

Off in DJI Go or everywhere? Did you try Sky Map? I have it spot on in the latter, but 90 degrees off in the former.

I did not notice any change in heating after upgrading to R1.5. The device gets warm when flying or charging, but no problems so far. DJI Go 4.3.0 was working fine with the previous firmware and compatible with M2 also.

Actually, could somebody with Moverio and DJI Go 4.3.0 confirm whether the attitude indicator works correctly? Mine is showing the aircraft and the map 90 degrees to the left of what it should be! Sky Map is spot on, so it should be the bug in DJI - it thinks I'm in portrait mode or something...

FYI, I finally calibrated the glasses! One just have to move the hand in figure 8 much faster than in the tutorial while keeping the wrist steady! Moverio buzzed 3 times and compass warning is gone.

No, I did not notice

I found no difference with or without antenna. I also had not experienced such a shortened range, I flew upto 2km over sea. Over a built up area I get poor connection warnings from remote + phone, without goggles, as I returned them.

That's calibrating the drone. I need to calibrate Moverio...

Many people reported shorter range. Both Goggles and the remote connect to Mavic, so looks like an interference.

well, I did the update, but still cannot calibrate the compass...

To me it looks like an overkill