Recent content by Scherping19

It’s official, I’m an idiot. You all were correct; I wired the black and the tan on opposite ends. I told myself to to look at other side when I did it but that’s what happen when you try to repair at midnight [emoji23]. Thanks everyone for the help. It is much appreciated. Now I need to work on...

Thank you. I thought the motor wire solders weren’t too bad. I was more concerned about the two small wires, for the LED possibly? How do I start the propellers without the aircraft lifting off? Sorry, I’m still fairly new to this. I’ve had it for about a month and flew it maybe 4-5 times.

Thanks Zaceshighz. Yes, they are in the correct spot (I took a picture before hand and compared to opposing side). The motor wires are away from the compass, they are routed almost the same way before I replaced the arm. As far as compass calibration, would a warning display if it was not...

Hi All - Recently, my Mavic Pro went into Atti mode and I crashed into a building (I'm not very experienced). The front left arm was broke. I purchased a replacement arm, disassembled my Mavic Pro, soldered the wires to the board and reassembled. I did have some difficulty soldering the wires...