Recent content by sirvancelot112

Update: I got it off. It was not that hard. The three screws were very hard to fully remove. I heated them up but the screw heads are all partially stripped and wouldn't be good candidates for reuse. The red/white/black wires are soldered or molded into the motor at several locations. Still not...

You are telling me this little silver disc is removable? Is it like a sticker?

Ah, understood. Appreciate that, thank you!

I'm having a hard time visualizing what you're saying. It seems that the spring pivot only fits in a certain way, I figured as long as it's flush and installed so that the screws align, it should be sufficient. No?

Thanks, me too. So heat gun the cap and then pry it off? I couldn't find youtube videos of anyone doing something similar.

Some do. It seems this one doesn't? It's from Aliexpress, I figure it comes as pictured. It was only $9.

Should I just forget this one and order a new arm with the motor included instead?

I was swapping motherboards between two of my Mini 3 Pros, and noticed that one of the 4x arm antenna connectors was damaged and would not reattach to the new motherboard. I cut it off thinking I could re-solder an undamaged connector on it, but the wire was far too intricate and delicate to be...